Getting Started with the Terrain Editor
This area is intended to familiarize you with all of the editing controls and their locations in the Terrain Editor for Aces High II. And, it will also show you how to start a new terrain.
Contents
The Terrain Editor Screen
Terrain Tab
The Terrain Tab is used while setting elevations and texture types on a terrain.
|
Set Type: Sets the terrain texture type for the area you are editing in the main window
Refresh Cnts: Refreshes the terrain texture type counts shown in the Terrain Tab Subtype: This only becomes active for river textures and allows you to select the direction a river travels. Randomize: Creates either completely random terrain textures across the whole terrain or randomizes the texture sub-types in a single grid Manual: Manually sets the terrain texture sub-types in a 1 mile grid Save Textures: Exports all of the terrain textures for viewing or editing Auto Type: Terr Alt: The altitude you want for the point(s) you are editing Set Terr Alt: Sets the altitude of the points you are editing at Terr Alt Inc Alt: Used to raise or lower the terrain in small increments. Raise: Raises the terrain by the value set in Inc Alt Lower: Lowers the terrain by the value set in Inc Alt Setup Filter: Used for creating natural looking hills and valleys over large areas Perform Op: Applies the filters set up in Setup Filter Show Transitions: Water Not 0: Checks for any areas of water that are not at 0 altitude Select: Selects an area to be copied Set Source: Sets the source point to be copied Set Destination: Sets the destination point to be copied Copy: Copies the selected area to the locations set in Set Source & Set Destination Mirror Right: Mirrors the selected area right or up(note: can be modified with Set Source and Set Destination) Flatten Terr: |
Objects Tab
The Objects Tab is used while placing objects such as bases, carrier groups and guns on your terrain.
Task Groups Tab
The Task Groups tab is used to assign initial paths to the Carrier Task Groups in the game.
|
List Window:
Add Point: Clear Points: Looped: Patrol: Submit: |
Roads Tab
The Roads Tab is where you assign routes for supply convoys (roads), trains, and barges that supply bases and strat in the game.
|
Set Properties:
Roads Drop Down List: Add, Delete Road: Insert, Add, Delete Point: Move To: Show All Roads: Create All: Redo Objects: Road Properties: |
Zones Tab
|
Field List:
Properties: Swap Zones: |
Map Window
|
Description here |
Terrain Window Options
|
Description here |
Position
|
Description here |
Terrain View
|
Description here |
Alt, Options, Time
Starting a New Terrain
--Nhawk 16:10, 16 April 2008 (UTC)








